![]() Both of them have specific benefits and downsides. A majority of house owners find it troubling to choose between cement siding and stucco. Scaffold to be erected corner to corner, or from a v-joint to a v-joint, from a tape-joint to a tape-joint, or from a construction joint to a construction joint.įor best results, the product should be applied by an experienced applicator.Tangled between fiber cement siding and stucco? You are not alone. The entire panel is to be redone, should remedial work be required. Recommended maximum panel size recommended for application, is 10M2. It has the lowest fire rating and will only burn as long as there is a flame.Īll new, previously painted or unstable surfaces need to be primed / bonded with a suitable primer provided by Versus Paint Specialists (Pty) Ltd. This product is water based and non-flammable. Minimum 12 Months, in an unopened container. Signed color sample panels are required prior to the manufacturing of product.Īlways store the container away from direct heat or sunlight. Note: Versus Paint Specialists (Pty) Ltd cannot be held liable for any color variations, should insufficient quantities be ordered. It is imperative that the correct quantity is ordered at the same time, to eliminate batch variance. Note: High pigment / bright colors will fade uniformly over time. Note: Dependent on ventilation and other climatic conditions. Note: Spread rates should be used as a guide only, as the actual spread rates will vary depending on the surface. It can also be applied onto any previously painted surfaces. It can be applied to the following surfaces: Gypsum (Rhinolite), OSB Board, Fibre cement board (Nutec), Wood. ![]() Versus Venetian Stucco is only suitable for interior, wall and ceiling surfaces. Note: Thinning will result in color variations. The product is a premixed, therefore no adding of water / thinning is required. Once the wax coat is dry, one can polished it off again, either by using a mutton cloth or for a high gloss finish by using a buffing machine. The final coat of Versus Venetian Stucco is a wax coat* that can be applied by either mutton cloth or trowel. Once dry, it is imperative that one lighly sands down between each coat to clean any excess material that may be left behind from the trowel. The first coat is for the obliteration of the surface and the subsequent 3 coats is to achieve the marble- look. Versus Venetian Stucco is applied by steel trowel. Prepare substrate by removing all loose and friable matter.Īll surfaces need to be properly prepared / primed, as per manufactures specification**Įnsure that the plaster surface is clean, dry and sound and in accordance with SABS 1514:1993 plaster specification and C.C.I – SANS 2001- EMI: 2007 SUCCESSFUL PLASTERING, (605 ACCURACY) Versus Venetian Stucco needs to be applied on to a rhinolite surfaceĮnvironmentally friendly < 13g / l VOC (Volatile Organic Compounds)* Moisture content of surfaces must be less than 2%,as the wax coat does not allow any moisture to escape. Versus Venetian Stucco is an internal only product and is durable and flexible, aesthetically pleasing, maintenance free and has excellent adhesion. ![]() Versus Venetian Stucco: A new generation of 100 % pure acrylic smooth plaster finish, using marble powders, various fillers and colored with iron oxide pigments. ![]()
0 Comments
Leave a Reply. |